อีเทคเฮดล็อค Gyro (G103)

Head Lock Gyro

Model: G103

Specification:

1. Input powerI: DC5V signal

2. Input 1.0-2.0ms

3. Weight: 13G 4. Size: 27X28.5X18mm

Function instruction:

REV/NOR Normal/Reverse Switch

LED Status indicator

Delay Gain adjustment

Limit Servo range control

Adjustment instruction

I: Delay Gyro Gain adjustment

Increase the adility of gyro to balance the helicopter (stable but less active),
Decrease the ability of gyro to balance the helicopter (active but less stable).
When adjusting the gain of gyro, the gain is differs when applied with different servos or

Different helicopters Generally speaking, the faster the tail servo responds the gyro's gain

Will increase. The faster the helicopter main rotors rotate, the tail servo's responds will be

Stronger, therefore the gain of gyro should be reduced.

II: REV/NOR Normal and Reverse Switch

REV Switch: Reversing switch for gyro Adjust the tail servo's direction.

REV: Reverse NOR: Normal motion

When checking the action direction of Gyro, lift up the helicopter and let the head of the

Helicopter turn left, if the direction of the tail servo turns is in accordance with the transmitter's

Stick turns, it indicates that initialization setting is right. Otherwise you should switch the

Normal and Reverse Switch of gyro.

Please double check to make sure that the action direction of the gyro is correct.

III: Limit Servo range control

Limit: Adjust the maximal range of tail servo.

A. When increase the range of tail servo will increase.

B. When decrease the range of tail servo will decrease.

Attention: Adjust the knob to limit the tail servo range within the maximal displacement range of the tail pitch sliding bush when the rocker of the tail servo being moved to both left and right fully, by doing this.

The range of tail servo won't exceed the limitation so as to protect the servo and the link lever when flying. On the other hand, don't adjust the servo's range too start to reduce the gyro's performance.

IV: LED Status indicator

Display status Status of gyro

Fast Flashing After powering on, the gyro is initializing

Constant light The gyro is locked

Extinguishing Power off or the gyro is unlocked

Slow flashing Gyro can not receive the tail servo control signal. The tail servo can't work

Intermittent flashing CH5 isn't connected well, or it moved to the middle during animalizing,

Remove the battery and connect again.