ซัพพลายเออร์ที่มีใบอนุญาตการทำธุรกิจ
ซัพพลายเออร์ที่ผ่านการตรวจสอบแล้ว Nylon 6I, through the introduction of aromatic rings into the basic molecular chain of nylon, so as to achieve the improvement of the heat resistance of nylon resin, low water absorption.
1) High heat resistance
With a high glass transition temperature, high rigidity is maintained even in the high temperature environment of the engine room.
2) Excellent chemical resistance
Demonstrated the best chemical resistance of polyamides.
3) Small size change caused by water absorption
The size change of water absorption belongs to the lowest category of polyamides, more than 50% lower than PA66.
Typical Characteristics:
| permanent transparency | high light transmission |
| high dimensional stability | easy processing |
| excellent abrasion | scratch resistance |
| superior impact resistance to high temperature | superior impact resistance to low temperature |
| good chemical and solvent resistance | high stress crack resistance |
| easily colorable | food contact approval |
| Item | Unit | Test Method | Values |
| Charpy Notched Impact Strength | KJ/m² | GB/T 1043-93 | 10 |
| Charpy Unnotched Impact Strength | KJ/m² | GB/T 1043-93 | 70 |
| Tensile Strength | MPa | GB/T 1040-92 | 85 |
| Elongation at Break | % | GB/T 1040-92 | 15 |
| Flexural Strength | MPa | GB 9341-2000 | 120 |
| Flexural Modulus | MPa | GB 9341-2000 | 2700 |
| Density | g/cm³ | GB 1033-86 | 1.18 |
| HDT (0.45 MPa) | ºC | GB1634-79 | 120 |
| HDT (1.8 MPa) | ºC | GB1634-79 | 110 |
| Shore Type D Hardness | -- | GB 2411-80 | 85 |
| 1. Coating material |
| 2. Cosmetic Packaging/Food Contact Packing |
| 3. Medical/Healthcare Applications |
| 4. Monolayer-blow Molded Tubes |
| 5. Automobile Components |
| 6. Film/Cast Film/Non-oriented Film/Oriented Film |
| 7. Blow Molding Container |
| 8. Textile |
Injection molding advice and reference(for reference only):
1) Molding equipment
Equipment needs to consider the situation of wear (flame retardant grade is corrosion resistance).
Select a small device with a single injection volume ≥ 10% of the maximum injection capacity.
A standard nozzle will do.
2) Mold:
Also need to consider the selection of wear (flame retardant grade is corrosion resistant) steel.
The exhaust tank is about 10μm.
3) Prepare for drying
After opening, the product that has been exposed to air (has absorbed water) must be redried.
Dehumidifying dryer: The temperature is 100ºC,2~6h
4) Standard molding conditions
Barrel temperature:
NH 320 (315~335)
C3 320 (320~335)
C2 320 (315~335)
C1 310 (300~325)
Lower hopper :70 (50~ 90)
Mold (non-enhanced grade)120 (90~140)
Injection speed: medium speed
Injection pressure: medium pressure
Screw speed :150rpm
ซัพพลายเออร์ที่มีใบอนุญาตการทำธุรกิจ
ซัพพลายเออร์ที่ผ่านการตรวจสอบแล้ว 
