แปรงขัดแบบยืดหยุ่นแปรงทำความสะอาดกระบอกสูบเครื่องยนต์

Flexible Honing Tools have round, abrasive beads fastened to the ends of flexible filaments. This self centering tool will conform to the bore surface providing a consistent, even surface finish over the life of the tool. The Flexible Honing Tool will even provide an "edge break" not possible with conventional honing stones.

 Typical Applications Include:
(1)Air Compressors Bores  (2) Compressed Air Tool Bodies  (3) Hydraulic Ram Cylinders  (4) Brake Cylinders (Wheel)  (5) Hydraulic Valve Bodies & Valve Guides  (6) Clutch and Brake Master Cylinders  (7) Hydraulic Motor Bodies  (8) Finishing of Stainless Steel Tubing (9) Pneumatic Cylinders  (10) Brake Rotors  (11) Surface finishing of Boiler Components (12)Engine Cylinders Bores and Block Liners.

Application specially size for Firearms/Revolvers (Pistols ,Handgun Cylinder) / Rifles' Chamber / Barrels/Painball Guns.Standard-duty Silicon Carbide flexible hones use on valve bodies,valve guides,lifter bores,brake cylinders,small engines,tubing and pneumatic cylinders.

Key Features:
1. Sturdy, self-centering stem.
2. Flexible filaments are engineered to provide the correct pressure to create an ideal hone - bore after bore.
3. Rigid abrasive media is firmly attached to the end of the flexible filaments making the tool excellent for tough cross-hole deburring and edge radiusing applications.
4. Fill Material:Silicon Carbide or Aluminum Oxide or others,different grit choice,such as #60,#120,#180,#240,#320#,600,#800,#1000…

Product Size:
1. Brush diameters ranging from 3.5mm to 600mm,Rotor hones diameters are 64mm & 76mm.  
2. Stem diameters ranging from 1.5mm to 10.5mm.
3. Brush length ranging from 40mm to 200mm.
4. Overall length ranging from 100mm to 420mm.

Instructions:
1. Choose the Flexible Honing Tool for your specific hole size. The actual Flexible Honing Tool will be approx 10% larger than the hole size.
2. Use 10-30 weight oil for honing lubrication, when honing hydraulic brake cylinders, use hydraulic brake fluid as a honing lubricant.
3. Have the Flexible Honing Tool rotating upon entry and removal from the bore.
4. Recommended RPM range for the Flexible Honing Tool is 50 to 100 RPM, based on the brush diameter. Air Tools are not recommended.
5. Use 30-40 strokes per minute depending on the RPM. Final stroking may be accelerated to develop a 45 degree cross-hatch angle.
6. Honing time should be approximately 20/45 seconds per bore.
7. Do not use solvents for honing or cleaning.
8. Clean cylinders after honing with warm or hot water and detergent using an plain nylon brush, and then lightly oil the bore.